ポータブル・ステレオ・システム eKids 430のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。eKids 430 5 ページ。 Cd boombox
eKids 430 にも： クイック・スタート・マニュアル (15 ページ), クイック・スタート・マニュアル (2 ページ), マニュアル (2 ページ), クイック・スタート・マニュアル (12 ページ)
ページを印刷する
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warning.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance
with the manufacture's instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding plug. A polarized plug has two blades with one
wider than the other. A grounding plug has two blades and
a third grounding prong. The wide blade or the third prong
is provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at the plugs, convenience receptacles, and at
the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Unplug the apparatus during lightning storms or when
unused for long periods operate during intended use.
13. Refer all servicing to qualified personnel. Servicing is
required when the apparatus has been damaged in any
way. Examples of damage include: Power supply cord or
plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been
dropped.
14. No naked flame sources, such as lighted candles, should be
placed on the apparatus.
15. Attention should be drawn to the environmental aspects of
battery disposal.
16. The use of apparauts in tropical and/or moderate climates.
17. CAUTION-Danger of exposion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
BASIC FUNCTION
SWITCHING ON THE UNIT
After connecting the power, press the
/SOURCE button to turn the unit ON, press
and hold the
/SOURCE button to turn the unit OFF.
NOTE: In CD/AUX/BLUETOOTH mode, when the unit is not providing the main
function for 15 minutes, the unit will automatically switch into standby mode. Press
the
/SOURCE button to turn on the unit again.
Please note that low volume setting in the audio source may be recognized as "no
audio signal", this will affect the capability of signal detection from the device and
can also originate an automatic switch into standby mode. If this happens please
reactivate the audio signal transmission or increase the volume setting on the audio
source player in order to resume playback.
Electrostatic Discharge hints - The unit may reset or may not reset to normal
operation mode due to electrostatic discharge, just switch it off and reconnect again.
ADJUSTING VOLUME
Press the VOL.+ or VOL.- button on unit to increase or decrease volume.
BLUETOOTH OPERATION
1. Press the
/SOURCE button on unit to select Bluetooth mode, the LCD will
display "bt".
2. Turn on the Bluetooth function on your device, and select "BT-430" to connect.
Input the password '0000' if required. The display will show "bt". Press
PLAY/PAUSE/REPEAT/PAIR button to start playback.
3. Press the VOL.+ or VOL.- button on unit or adjust the volume on the external
device to your desired level.
4. Press
or
on unit to choose the desired track.
5. To stop playback, press PLAY/PAUSE/REPEAT/PAIR button on unit.
6. Press and hold PLAY/PAUSE/REPEAT/PAIR button to disconnect Bluetooth.
Note: The Bluetooth works best within 10 meters in open air.
CD OPERATION
Discs for Playback
This system can playback all digital audio CD, finalized digital audio CD-Recordable
(CD-R) discs, finalized digital audio CD-Rewritable (CD-RW) discs.
LOADING A DISC
1. Press the
/SOURCE button on unit to select "CD" mode.
2. Push to open CD door, "OP" will be shown on the display.
3. Place an audio CD into the tray with the front side facing up.
4. Close the CD door, the display will show a flashing "- -", then the playback will
start from the first track.
5. To remove the CD, press STOP/PROG button to stop, then open the CD
compartment lid. Hold the CD by its edges, and take it out carefully.
Note:
1. Make sure the disc is stopped before opening the CD DOOR.
2. To ensure good system performance, wait until the unit completely reads the disc
before proceeding.
3. If no disc loaded into the tray, or the disc is unreadable, the display will show
"NO".
PLAYING A DISC
1. The playback starts from track 1, Press the PLAY/PAUSE/REPEAT/PAIR button
to pause playback, the ► indicator and the current track will flash on the display.
To resume playback, press the PLAY/PAUSE/REPEAT/PAIR button again.
2. To stop playback, press the STOP/PROG button, the total number of tracks
appears on the display.
430.5ONLINEIB-ENG-061920-A
WARNING:
To reduce the risk of fire or electric shock, do not expose this
appliance to rain or moisture.
CAUTION:
Use of controls or adjustments or performance of procedures
other than those specified may result in hazardous radiation
exposure.
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE
PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an
equilateral triangle, is intended to alert the user to the
presence of non-insulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
• The apparatus shall not be exposed to dripping or splashing
and that no objects filled with liquids, such as vases, shall be
placed on apparatus.
• Mains plug is used as disconnect device and it should remain
readily operable during intended use. In order to disconnect
the apparatus from the mains completely, the mains plug
should be disconnected form the mains socket outlet
completely.
• Battery shall not be exposed to excessive heat such as
sunshine, fire or the like.
DANGER!
This Compact disc player is classified
as a Class 1 LASER PRODUCT.
THE CLASS 1 LASER PRODUCT
label is located on the rear exterior.
© 2020 eKids, LLC
PO Box 2228
BELFAST, BT5 9GD
CONTROLS
3
4
5
6
10
14
1. HANDLE
2. CD COMPARTMENT
3. NEXT/FAST FORWARD BUTTON
4. PREV/FAST BACKWARD BUTTON
5. VOL. - BUTTON
6.
/SOURCE BUTTON
7. PLAY/PAUSE/REPEAT/PAIR BUTTON
8. STOP/PROG BUTTON
9. VOL.+ BUTTON
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled
or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and
human health due to the presence of hazardous substances.
Getting Started
ACCESSORIES:
Instruction Booklet: 1pc
AC Cord: 1 pc
POWER SOURCE
This unit is designed to be operated on AC or DC power.
AC OPERATION
Plug the tail of AC power cord into AC socket on the unit and the plug
into household AC outlet.
DC OPERATION
Open the BATTERY COMPARTMENT DOOR. Install 6 pcs UM-2/C
size batteries (not included) into compartment. Please follow correct
polarities as indicated. Disconnect the power supply cable from the
back of unit.
For the Best Possible Performance
• Only use the recommended/supplied batteries or equivalent.
• Rechargeable batteries are to be removed from the unit before being charged.
• The supply terminals are not to be short-circuited.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable nickel-cadmium batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Recharge rechargeable batteries under adult supervision.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal ambient temperatures.
• To prevent battery leakage or damage remove batteries from a product if it will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact
with eyes, IMMEDIATELY flush the eye with lukewarm and gently flowing water for at least 30 minutes. If skin contact occurs,
wash skin with clear water for at least 15 minutes. Seek medical attention if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or combustible material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the disposal and transportation of batteries.
• Do not dispose of batteries in fire; batteries may leak or explode.
• Batteries should be replaced by an adult.
• Remove all packaging before giving to your child.
1
2
11 12
7
8
9
17
10
16
15
13
10. SPEAKERS
11. STB INDICATOR
12. LCD DISPLAY
13. BATTERY COMPARTMENT
14. AC SOCKET
15. AUX-IN JACK
16. MIC JACK
17. MICROPHONE
CD Boombox
POWER REQUIREMENTS:
Power Source: AC100-240V ~ 50/60Hz
DC 9V 1.5V UM-2/C x 6pcs (batteries not included)
DC 1.5V
DC 1.5V
UM-2 "C"size
UM-2 "C"size
DC 1.5V
DC 1.5V
UM-2 "C"size
UM-2 "C"size
DC 1.5V
DC 1.5V
UM-2 "C"size
UM-2 "C"size
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the
or
button on unit while in stop mode, until the desired track appears
on the display. Then press the PLAY/PAUSE/REPEAT/PAIR button to play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the
or
button on unit to scan the current playing track at high
speed until desired point (passage) appears, then release the button for normal
playback mode. Playback w ill start again from this point.
PROGRAMMING TRACKS
Programming tracks is possible when playback is stopped. Up to 20 tracks of a CD
can be stored in the memory in any order.
1. In stop mode, press and hold the STOP/PROG button. The unit enters program
setting, the "PROGRAM" indicator will flash on the display and show P01.
2. Press the
or
button to select the first desired track to be programmed.
(example: track 2)
3. Press and hold the STOP/PROG button on unit to enter. The display would flash
PROGRAM and show P02.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5. Press the PLAY/PAUSE/REPEAT/PAIR button on unit to start playback from the
first programmed track.
6. Press the STOP/PROG button on unit to stop program playback. To clear the
program, you may press STOP/PROG button on unit when the disc stopped and
open the CD compartment lid, the program will be erased.
REPEAT PLAY
You can play one track or all tracks on the disc repeatedly.
To Repeat a Single Track
1. Press and hold PLAY/PAUSE/REPEAT/PAIR button during play, the display will
show a flash "REPEAT" indicator and the current track will be played over and over
again.
2. To cancel repeat play, press and hold the PLAY/PAUSE/REPEAT/PAIR button
repeatly until "REPEAT" disappears from the display.
To repeat all the Tracks
1. Press and hold PLAY/PAUSE/REPEAT/PAIR button while in Repeat Single Track
mode until the "REPEAT" indicator shows steadily on the display, all tracks on the
disc will be played over and over again.
2. To cancel repeat play, press and hold the PLAY/PAUSE/REPEAT/PAIR button
repeatly until "REPEAT" disappears from the display.
RANDOM PLAY
Press and hold the PLAY/PAUSE/REPEAT/PAIR button repeatly till the "RAN" shows
steadily on the display, the random play will start from next track automatically, until all
tracks are played over and then it will stop. To cancel, press and hold the
PLAY/PAUSE/REPEAT/PAIR button until the "RAN" disappears from the display.
AUX-IN OPERATION
1. Press the
/SOURCE button to select "AUX" mode.
2. Insert one end of a AUX line plug into the AUX IN jack (3.5mm) on the unit, and the
other end to the headphone jack of your music device to amplify music.
3. Control play/pause and navigate tracks using your music device.
4. Adjust the volume on the unit or on the device to your desired level.
MICROPHONE OPERATION
This unit provides one 3.5mm Mic Jack for Karaoke function. The microphone is
available in all modes. Connect a 3.5mm microphone to the mic jack, then turn on the
microphone.
ENG
Model: 430 Series
BATTERY
INSTALLATION
OPEN
OPEN