- ページ 5

コントローラー HID Aero X1100のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。HID Aero X1100 8 ページ。 Intelligent controller

ページを印刷する

Powering

Trusted Identities

Input power, cabinet tamper, and UPS fault input wiring

The X1100 requires 12-24 V DC power. Connect power

with minimum of 18 AWG wire.

Connect the power ground to earth ground in only

ONE LOCATION within the system. Multiple earth

ground connections may cause ground loop problems

and is not advised.

Observe POLARITY on 12-24 V DC input.

Connect the AC FAIL and BATT FAIL inputs to the

corresponding contacts provided on the power supply.

Connect the TAMPER input to a tamper switch on the

enclosure.

Bulk erase configuration memory

The bulk erase function can be used for the following:

Erase all configuration and cardholder database (sanitize board, less third party applications).

Recover from database corruption causing X1100 board to continuously reboot.

Note: If clearing the memory does not correct the initialization problem, contact technical support.

Bulk erase steps

1. Set DIP switches 1 and 2 to ON, and 3 and 4 to OFF.

2. Apply power to the X1100 board.

3. LED ONLINE is on for about 15 seconds while the X1100 boots up.

4. Change DIP switches 1 or 2 to OFF within 10 seconds, after LEDs ONLINE and HOST COMM and LEDs IO INTERNAL

and IO PORT 1 start flashing alternately at a rate of 0.5 seconds.

Note: If these switches are not changed, the X1100 board will power up using the OEM default communication

parameters.

5. LED HOST COMM will flash, indicating that the configuration memory is being erased.

Note: Full memory erase takes up to 60 seconds.

6. When complete, only LEDs ONLINE and IO PORT 1 will flash for about 3 seconds.

7. The X1100 board will complete its initialization two seconds after LEDs ONLINE & IO PORT 1 stop flashing.

CAUTION: Do not remove power during the bulk erase process.

IT security

Ensure that the X1100 is installed securely. Create user

accounts to the web configuration page using secure

passwords.

Ensure that all DIP switches are in the OFF position for the

normal operating mode.

After powering up the X1100 and connecting Ethernet,

connect to the X1100 configuration manager by opening a

browser and connecting to 192.168.0.251.

The X1100 is shipped with a default login account, which

is enabled when DIP 1 is moved from OFF to ON (See step

6. DIP switch configuration). The default login User Name

(admin) and Password (password) will be available for

five minutes once the DIP switch is toggled. It is therefore

important that at least one user account is defined, and

the DIP switches are set to OFF before the X1100 is

commissioned.

Configuring the X1100 with an IP address that is accessible

from the public Internet is not recommended.

PLT-04233, Rev. A.3

HID Aero™ X1100 Installation Guide

TAMPER, AC FAIL, and BATT FAIL connections are

identical to inputs IN 1 to IN 4 and can be configured

as unsupervised or supervised. See step 7. Input circuit

wiring.

The following options are available to improve network

security:

Disable SNMP.

Disable Zeroconf discovery.

Disable the web configuration module.

Enable data encryption over the host

communication port.