- ページ 16

ストレージ Fujitsu ETERNUS4000' ETERNUS8000のPDF サーバー接続マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ETERNUS4000' ETERNUS8000 21 ページ。

Chapter 2 ETERNUS Disk Storage System Connection Settings

2.1 Common Settings

2.1.6

Setting CHAP Authentication

The ETERNUS Disk storage system supports the use of CHAP authentication. This section

describes the procedure for setting CHAP authentication in the ETERNUS Disk storage system.

This setting can be omitted.

Procedure

P3AM-4172-02ENZ0

Server Connection Guide (iSCSI) ETERNUS Disk Storage System Settings

To set CHAP authentication, set "CHAP" to "ON" in advance according to

"2.1.1 Setting the To-server Connection Type (Setting the CA Parameters)"

(page

11). To set bidirectional CHAP authentication, specify a user name

and password for the iSCSI port in advance.

Click the [Set iSCSI Host] under the [Configuration] or [Setting RAID/Setting

Host] menu.

If an iSNS server with the server iSCSI name registered does not

exist in the network, [Retrieve iSCSI Host] cannot be used.

When the iSNS server does not exist, enter the server iSCSI

information manually.

Click the [Add] button, and enter the server iSCSI information, user name, and

password.

Specify the user name and password of the server to be connected within the following

range.

•

User Name

Up to 255 alphanumeric characters and symbols can be used.

•

Password

Between 12 and 16 alphanumeric characters and symbols can be used if a LAN card is

used as the server adapter.

Between 12 and 100 alphanumeric characters and symbols can be used if an iSCSI

HBA is used as the server adapter.

If the server iSCSI settings have already been performed, select the

server from the "iSCSI registration list", specify the user name and

password, and then click the [OK] button.

End of procedure