- ページ 13

バスルーム設備 Kohler BodySpa K-1000のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler BodySpa K-1000 28 ページ。 Tower custom hydro-massage system
Kohler BodySpa K-1000 にも：ホームオーナーズマニュアル (48 ページ)

ページを印刷する

D. INSTALL THE HEADER

With assistance, lift the header between the center

expanders so the bottom dimpled holes in the header

brackets fit over the adjustment screws. Check the

alignment of the side holes in both header brackets to the

adjustment screw heads. If the holes do not line up with

the adjustment screw heads, loosen the header

bracket(s) setscrews, and realign the header bracket(s)

until the holes line up with the adjustment screw heads.

Retighten the header bracket setscrews.

Add a 1/4" flat washer to each of the two buttonhead

screws. Thread a buttonhead screw and washer through

each header bracket top hole, and into the center

expander. Securely tighten each buttonhead screw with

the supplied hex socket tool and a ratchet wrench.

Measure the header height from the footbath rim at the

end, and again in the center, as shown. Compare the

distance. The header should be 1/4" higher at the center.

The combined weight of the door panels will pull the

header down until it is level or close to level.

Adjust the level of the header by first loosening the

buttonhead screw securing the header to the center

expander. Now back out the adjustment screw one or two

turns. Retighten the buttonhead screw with the hex socket

tool and ratchet. This will cause the header to pivot slightly

upward.

Alternate this procedure on both ends of the header, and

again measure the header height at the end and the

center. Repeat until the header is 1/4" higher at the center.

Be sure to securely tighten the buttonhead screws with

the hex socket tool and ratchet when the adjustments are

complete.

Very Important! The header must be 1/4" higher at the

center before proceeding. The center of the header must

not sag downward or the door panels will not operate

correctly.

Kohler Co., Kohler WI U.S.A.

Header

1/4-20 x 5/8"

Buttonhead

Screw

1/4" Washer

Header

Bracket

End

Tape

Measure

Buttonhead Screw

Adjustment Screw

Setscrew

Adjustment

Screw

Center Expander

Center

Header

116290-2-