- ページ 10

浄水器 AQUAPHOR OSMO PRO 50 EUのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AQUAPHOR OSMO PRO 50 EU 16 ページ。

Changing the replacement cartridges

The service life of the membrane cartridge (3) de-

pends on the performance of the water treatment

unit (2), therefore it is very important to replace

the Pro 1 cartridge in a timely manner.

Replacing Pro M / Pro HFM

Cartridges

• Close the tap on the storage tank.

• Close the inlet tap on the connection unit and

open the clean water tap to relieve pressure.

• Turn the used cartridge counterclockwise and

remove it.

• Remove the packing tape from the new cartridge.

• Insert the new cartridge into the housing as far

as it will go and, using slight pressure, turn the

cartridge clockwise until it clicks.

• Install the flush plug in the middle slot (instead

of the membrane cartridge).

• Open the inlet tap on the connection unit (23)

and the clean water tap (7).

• Drain the water passing through the OSMO Pro

for 10 minutes.

• Close the inlet and clean water tap.

• Remove the flush plug and install the membrane

cartridge by turning the cartridge clockwise

until it clicks.

• Open the inlet tap and check that the OSMO

Pro connections are tight.

Replacing the membrane

cartridge

• Close the tap on the storage tank.

• Close the inlet tap on the connection unit and

open the clean water tap to relieve pressure.

• Turn the used membrane cartridge counter-

clockwise and remove it.

• Remove the packing tape from the new cartridge.

• Insert the new cartridge into the housing as far

as it will go and, using slight pressure, turn the

cartridge clockwise until it clicks.

• Open the inlet tap on the connection unit, the

storage tank tap and the clean water tap.

• Drain the OSMO Pro for 1 hour.

• Close the clean water tap.

• Make sure the OSMO Pro connections are tight.