AQUAPHOR OSMO PRO 50 EU 매뉴얼 - 페이지 10

{카테고리_이름} AQUAPHOR OSMO PRO 50 EU에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR OSMO PRO 50 EU 16 페이지.

Changing the replacement cartridges

The service life of the membrane cartridge (3) de-

pends on the performance of the water treatment

unit (2), therefore it is very important to replace

the Pro 1 cartridge in a timely manner.

Replacing Pro M / Pro HFM

Cartridges

• Close the tap on the storage tank.

• Close the inlet tap on the connection unit and

open the clean water tap to relieve pressure.

• Turn the used cartridge counterclockwise and

remove it.

• Remove the packing tape from the new cartridge.

• Insert the new cartridge into the housing as far

as it will go and, using slight pressure, turn the

cartridge clockwise until it clicks.

• Install the flush plug in the middle slot (instead

of the membrane cartridge).

• Open the inlet tap on the connection unit (23)

and the clean water tap (7).

• Drain the water passing through the OSMO Pro

for 10 minutes.

• Close the inlet and clean water tap.

• Remove the flush plug and install the membrane

cartridge by turning the cartridge clockwise

until it clicks.

• Open the inlet tap and check that the OSMO

Pro connections are tight.

Replacing the membrane

cartridge

• Close the tap on the storage tank.

• Close the inlet tap on the connection unit and

open the clean water tap to relieve pressure.

• Turn the used membrane cartridge counter-

clockwise and remove it.

• Remove the packing tape from the new cartridge.

• Insert the new cartridge into the housing as far

as it will go and, using slight pressure, turn the

cartridge clockwise until it clicks.

• Open the inlet tap on the connection unit, the

storage tank tap and the clean water tap.

• Drain the OSMO Pro for 1 hour.

• Close the clean water tap.

• Make sure the OSMO Pro connections are tight.