- ページ 6

プロジェクター Sharp XG-PH50X - XGA DLP ProjectorのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Sharp XG-PH50X - XGA DLP Projector 13 ページ。 Xga native resolution system integration/large venue projector
Sharp XG-PH50X - XGA DLP Projector にも：インストレーション・マニュアル (2 ページ), 操作マニュアル (20 ページ), 仕様 (2 ページ), パンフレット＆スペック (4 ページ), クイック・スタート・リファレンス・シート (6 ページ)

INSTALLATION INSTRUCTIONS

STEP 3 DETACH THE POSITIONING ASSEMBLY FROM THE PROJECTOR ATTACHMENT

PLATE.

FIGURE 5

POSITIONING KNUCKLE ASSEMBLY

REMOVE NUT

LOWER KNUCKLE

STEP 4 INSTALLATION OF THE PROJECTOR ATTACHMENT PLATE

4.1

Place the attachment plate over the bottom of the projector (See Fig. 6)

and align the holes of the plate with the threaded fittings on the projector case.

4.2

Install the three M4 x 12mm long screws provided. Fasten these securely but

DO NOT overtighten. (See Fig. 7)

FIGURE 6.

NOTE: PLEASE LOOK OVER THE EXACT MANNER IN WHICH THE

POSITIONING ASSEMBLY AND THE ATTACHMENT PLATE GO

TOGETHER SO THAT YOU WILL BE ABLE TO REASSEMBLE THEM

WHEN YOU HANG THE PROJECTOR.

3.1 Using 9/16" box wrench, remove the nut and split lock washer from the lower

knuckle (vertical position) and slide the center and upper knuckle assembly apart

from the bottom knuckle which is part of the

attachment plate. (See Fig. 5)

SPECIAL NOTE TO INSTALLERS: The positioning knuckle is mounted to provide

correct static balance when the standard lens is used.

When any of the other lens options are used the lens is

heavier and in order to improve the static balance, move

the 3 piece knuckle

assembly to one of the other mounting holes on the at-

tachment plate. If the larger and heavier lens is selected,

use the furthest hole. All other mounting and adjustment

procedures remain the same.

FIGURE 7.

PAGE 6

CEILING BRACKET AN-PHCM20

M4x12mm screws