- ページ 7

楽器 Artist Guitars TL DIY KITのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Artist Guitars TL DIY KIT 14 ページ。

TL DIY KIT MANUAL

NECK

With the body placed face up on a protective surface, position the neck

into the neck cutout until it is fully inserted.

Turn the assembly over and position the neck plate (with its black protective

seal) over the four bolt holes at the rear of the body and drive in the four

long screws through the neck plate, body and pilot holes in the neck until all

ﬁts tightly

The pickups and controls are pre-assembled on the pickguard and simply

need to be connected to the output jack socket and earth. Wiring is

implemented as plug-in modules, soldering is not required.

The neck pickup is pre-assembled on the pickguard, however, the bridge

pickup is pre-assembled on the bridge. Each pickup has one loose cable.

Insert the cable with connector into the small hole in each pickup cavity until

it runs through and reaches the cavity of the control panel.