Artist Guitars TL DIY KIT 매뉴얼 - 페이지 7

{카테고리_이름} Artist Guitars TL DIY KIT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artist Guitars TL DIY KIT 14 페이지.

TL DIY KIT MANUAL

NECK

With the body placed face up on a protective surface, position the neck

into the neck cutout until it is fully inserted.

Turn the assembly over and position the neck plate (with its black protective

seal) over the four bolt holes at the rear of the body and drive in the four

long screws through the neck plate, body and pilot holes in the neck until all

ﬁts tightly

The pickups and controls are pre-assembled on the pickguard and simply

need to be connected to the output jack socket and earth. Wiring is

implemented as plug-in modules, soldering is not required.

The neck pickup is pre-assembled on the pickguard, however, the bridge

pickup is pre-assembled on the bridge. Each pickup has one loose cable.

Insert the cable with connector into the small hole in each pickup cavity until

it runs through and reaches the cavity of the control panel.