BobsCNC KL744 조립 설명서 - 페이지 10

{카테고리_이름} BobsCNC KL744에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BobsCNC KL744 20 페이지. Table assembly
BobsCNC KL744에 대해서도 마찬가지입니다: 시작하기 (9 페이지), 조립 설명서 (12 페이지)

페이지 인쇄
BobsCNC KL744 조립 설명서
With the X2 Mid Rail assembly on a large flat work surface set the
Step 4
third X2 Mid Rail beside it as shown.
NOTE: In the photo below the assembly is setting on the KL744 Optional Table.
Align slots of the X Frame Side Assembly with the X2 Mid Rail Supports as
shown. Carefully slide the slots down until the bottom of the slot rests on the
base of X Frame Side Assembly. The tabs on the X2 Mid Rail Supports will fit
in slots of the X Frame Side Assembly. Secure with four 5/16 x 1 1/4 Machine
Screws and Nuts.
Repeat to install the remaining X Frame Side Assembly on the opposite
side.
Slot
Page 10
Tab