DoorHan PCB-SH 프로그래밍 지침 매뉴얼 - 페이지 11
{카테고리_이름} DoorHan PCB-SH에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH 14 페이지. Control board
DoorHan PCB-SH에 대해서도 마찬가지입니다: 프로그래밍 지침 매뉴얼 (16 페이지), 프로그래밍 지침 매뉴얼 (12 페이지)
페이지 인쇄
Diagram of PCB-SH, traffic light and Lamp
2. PROGRAMMING OF REMOTE CONTROL PANELS
2.1. SELECTING THE OPERATING MODE
Selection of operating mode is by pressing of button "P". Number of clicks will correspond to number of selected operating
mode.
The «Program» indicator shows the selected operation mode, the number of flashes corresponds to the number of the
preset mode:
Operating
PROGRAM indicator
mode
flashes
1
1 time
2
2 times
3
3 times
4
4 times
5
5 times
NOTE:
•
It is recommended to use pulse operation mode for door closing (modes 2, 4, 5) only when safety photocells are
available.
•
It is possible to use an external radio receiver only in modes 4 or 5.
Gate opening
Pulse pressing of «Open» button
Pulse pressing of «Open» button»
Holding of «Open» button
Pulse pressing of «Open» button.
Stepped behaviour
(open–stop–close)
Pulse pressing of «Open» button.
Stepped behaviour
(open–stop–close)
Gate closing
Pulse pressing of «Close» button
Pulse pressing of «Close» button
Holding of «Close» button
Pulse pressing of «Close» button
Pulse pressing of «Close» button
DRIVE PROGRAMMING
Automatic closing
No
No
No
No
Yes
11