DoorHan PCB-SH Programlama Talimatları Kılavuzu - Sayfa 11
Kapı Açıcı DoorHan PCB-SH için çevrimiçi göz atın veya pdf Programlama Talimatları Kılavuzu indirin. DoorHan PCB-SH 14 sayfaları. Control board
Ayrıca DoorHan PCB-SH için: Programlama Talimatları Kılavuzu (16 sayfalar), Programlama Talimatları Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Diagram of PCB-SH, traffic light and Lamp
2. PROGRAMMING OF REMOTE CONTROL PANELS
2.1. SELECTING THE OPERATING MODE
Selection of operating mode is by pressing of button "P". Number of clicks will correspond to number of selected operating
mode.
The «Program» indicator shows the selected operation mode, the number of flashes corresponds to the number of the
preset mode:
Operating
PROGRAM indicator
mode
flashes
1
1 time
2
2 times
3
3 times
4
4 times
5
5 times
NOTE:
•
It is recommended to use pulse operation mode for door closing (modes 2, 4, 5) only when safety photocells are
available.
•
It is possible to use an external radio receiver only in modes 4 or 5.
Gate opening
Pulse pressing of «Open» button
Pulse pressing of «Open» button»
Holding of «Open» button
Pulse pressing of «Open» button.
Stepped behaviour
(open–stop–close)
Pulse pressing of «Open» button.
Stepped behaviour
(open–stop–close)
Gate closing
Pulse pressing of «Close» button
Pulse pressing of «Close» button
Holding of «Close» button
Pulse pressing of «Close» button
Pulse pressing of «Close» button
DRIVE PROGRAMMING
Automatic closing
No
No
No
No
Yes
11