Ankom TDF Series 서비스 절차 - 페이지 7

{카테고리_이름} Ankom TDF Series에 대한 서비스 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Ankom TDF Series 9 페이지. Vacuum sensor installation
Ankom TDF Series에 대해서도 마찬가지입니다: 서비스 절차 (7 페이지), 서비스 절차 (4 페이지)

페이지 인쇄

16.

Secure the Shoulder Screw in place.

a. Tilt the instrument forward to access the back once

again.

b. Remove the Shoulder Screw installed finger-tight in the

previous step.

c. Apply a drop of Loctite 242 (provided in the new

Paddle Bar kit) to the threads of this screw.

d. Re-install the screw (do Not to get the Loctite on the

brass Rod End of the Mixer Piston) and tighten with the

⅛" Hex key wrench.

e. Return the instrument to its upright position.

f. Reinstall the two Service Access screws.

ANKOM Technology  2052 O'Neil Road  Email: [email protected] Phone: 315-986-8090  Fax: 315-986-8091

Paddle Bar Replacement

TDF

Service Procedure

Apply

Loctite

1/8"

Hex key

Wrench

Service

Access

Screws

TS021

Revised: 01/24/2017

pg. 7 of 9