daltile One Quartz Series 설치 매뉴얼 - 페이지 11
{카테고리_이름} daltile One Quartz Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. daltile One Quartz Series 15 페이지. Fabrication instructions
페이지 인쇄Daltile
A fabrication shop, large or small, will require most of the tools listed in this section.
While the following is a brief overview of some of the basic tools and equipment required in a
shop in order to fabricate ONE Quartz, it is not intended to be comprehensive or complete and
should not be solely relied upon for information. This overview does not address any personnel
safety equipment or requirements. Contact OSHA and your local Employment Development
Department for that information.
Handling and Storage Equipment
Cutting and Grinding Supplies
Note: Tools mentioned above are a condensed version of the tools and equipment found in
Fabrication Shops. Please ask your tool suppliers for additional tool and equipment
recommendations.
Remember, every shop has different needs. Each tool has its own advantages and
disadvantages. The tools listed in this manual are for your consideration only. It is important to
evaluate your individual needs and set up your shop according to those needs within
compliance of all federal, state, and local guidelines.
11
Hand Tools
Adhesives
Polishing Supplies
Safety Equipment
Accessories
ONE Quartz
Fork lift, vacuum lifter or slab clamp, lifting boom, A-frames,
slab storage racks, A-frame carts, slab dolly, vacuum cups,
work bench/fabrication tables, and racks for finished pieces.
Rail saw/polishers (air or electric) that are usually 4" and must
be variable speed with center water feed. Angle grinders for
hand cutting and shaping (min. 5"), router and appropriate
profile cutters (4") and clamps for laminating if needed.
The following two component adhesives are commonly used
in a fabrication: flow and/or knife grade epoxy, polyester,
methacrylate, ester, and penetrating acrylic. Also required are
appropriate pigments.
Diamond granite blade, properly sized to fit rail saw, turbo
diamond blades properly sized to fit angle grinders (4" min.
diamond cup wheels), 5" contour blade for cutting radius,
zero tolerance grinding drums 50 & 80 grit, and core bits for
faucet or grommet holes (usually 1 ⅜" to 2 ½").
3" and 4" flexible and ridged backer discs (velcro), 3"and 4"
polishing pads (50, 100, 200, 400, 800, 1500,3000 grit), final
polish pad, granite polishing powder, and felt pad.
Note: grit combinations vary with different manufacturers.
Respiratory dust masks, ear plugs, safety glasses, steel toe
rubber boots, waterproof aprons, gloves, back supports, and
ground fault interrupters for all electrical applications.
Tape measures, carpenters square, combination square, bevel
square, angle finder, compass, C-clamps, bar clamps,
extension cords, air hoses
and accessories, 4' level, 8' straight edge, whiteout pens/china
markers, rags, acetone or denatured alcohol (preferred),
single edge razor blades, propane torch & tips, steel wool,
masking tape, and shims.