daltile One Quartz Series 설치 매뉴얼 - 페이지 6
{카테고리_이름} daltile One Quartz Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. daltile One Quartz Series 15 페이지. Fabrication instructions
페이지 인쇄Daltile
"L" shaped cabinets joined together at an angle are common configurations used to negotiate a
corner. When building tops for these areas, it is advisable to place a seam at the corner rather
than building one top.
The advantages of seaming the top are as follows:
•
•
•
•
There are three basic seam configurations used in corners as follows:
•
•
•
6
Reduced chance of breakage during fabrication
Reduced chance of breakage during transportation
Reduced chance of breakage after installation due to stress at the corner
Improved ease of transporting and handling
Key cut - this is the most efficient seam configuration from the stand point of material
yield and labor costs. (Shown Below)
2" return with 1 ½" radius cut on the inside corner - many shops prefer this seam
configuration for aesthetic reasons, and to match other inside corners cut like this
without seams on the same job.
Mitered seam - this configuration is not commonly used because of poor material yield
and it creates a longer seam that's more difficult to deal with.
ONE Quartz