Dunster House HANGOVER APEX G4-1824HAB 설치 매뉴얼 - 페이지 14

{카테고리_이름} Dunster House HANGOVER APEX G4-1824HAB에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunster House HANGOVER APEX G4-1824HAB 18 페이지. Bar 1.8m x 2.4m (6ft x 8ft)

G4 - 1824HAB HANGOVER APEX BAR 1.8m x 2.4m - Assembly Steps
STEP 6: ROOF
Items:
1x WPC 2400x1200x10.Z
1x WPC 2400x600x10.Z
1x WPC 2400x100x10.B
1x WPC 2400x100x10.C
2x ST-PT3535570.00.60
2x ST-PT35351180.00.75
2x ST-PT35352400
2x Z.115.B
NOTE:
The layout of your doors can be changed by installing the relevant
Panels on the opposite side of your Hangover Bar.
Eaves Edging:
Fix the eaves edging batten - 2x ST-PT3535570.00.60, 2x
ST-PT35351180.00.75 & 2x ST-PT35352400 to your
shed as shown in the diagram.
Use 19x 60mm Screws ensuring they are evenly spread.
Z.115.B
WPC 2400x600x10.Z
Roof Trim
Fix 1x WPC 2400x100x10.C and 1x WPC
2400X100X10.B (trim) as shown in the image
to the left.
Using 8x 25mm HEXAGON SCREW
25mm+SADDLE+CAP.
Finials:
Position 2x Z.115.B (Finials) as shown in the diagram above.
To fix each finial, use 2x 35mm Screws.
** Pre-drill parts before fixing screws **
24x HEXAGON SCREW 25mm+SADDLE+CAP
19x 60mm Screws
4x 35mm Screw
1x SELF-ADHESIVE METALLIC FLASHING STRIP
(3.75M)
WPC 2400x1200x10.Z
Z.115.B
HEXAGON SCREW 25mm+SADDLE WASHER+CAP
SCREW 60 mm
Roof:
Fix 1x WPC 2400x1200x10.Z onto the top of your shed to seal
the roof assembly.
Using 8x 25mm HEXAGON SCREW 25mm+SADDLE+CAP
Ensuring that the edges are flush with the eaves edging.
Fix 1x WPC 2400x600x10.Z on to the smaller side of the shed.
Using 8x 25mm HEXAGON SCREW 25mm+SADDLE+CAP.
Ensuring that the edges are flush with the eaves edging.
Ensure the roof is fixed onto the previously assembled support.
Apply Self-adhesive metallic flashing strip where the 2 WPC
panels meet, use the Primer provided and follow the instruction on
the tin. Ensure the strip covers both WPC panels evenly. Refer to
the diagram on the left.
WPC 2400X100x10.C
ST-PT35351180.00.75
ST-PT3535570.00.60
WPC 2400x100x10.B
ST-PT35352400
Page 14