DUSKWORK VCO V2 빌드 매뉴얼 - 페이지 3

{카테고리_이름} DUSKWORK VCO V2에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DUSKWORK VCO V2 7 페이지.

| DUSKWORK.NET | Self-Tuning VCO V2 Build Guide

Step 3: Next, you'll need to add 1 x 300KΩ 1/4w resistor between pins 15 + 16 of the AS3340

IC. It's important that this doesn't short anywhere else on the PCB or other components. The

best way to do this is to bend one leg against the body of the resistor to reduce the size of its

footprint. See photos below for to visualise how it should sit.

Before

After

Step 4: Now it's time to start soldering the through hole components. Start with the 2 x 10K

trim pots at the top of the board. One is to adjust the 1v reference signal, the other is to

adjust the 1v/oct CV tracking