Austdac HUBBUS HBLTU 사용자 설명서 - 페이지 11
{카테고리_이름} Austdac HUBBUS HBLTU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Austdac HUBBUS HBLTU 12 페이지. Termination unit
페이지 인쇄6 Terminals
6.1 TYPE
The PCB terminal connector is a Phoenix Contact style with 5.08mm pitch. Austdac
supplies the module with either a 90˚ free hanging push-in spring terminal plug.
6.2 LAYOUT
6.2.1 Termination Connection
If system termination is determined to be required, HubBus signal shall be
connected to the "Term 1" terminals; if no system termination is required, HubBus
signal shall be connected to the "No Term" terminals. "Term 2" and "Term 3"
terminals are not currently used but are provided for future development only.
WARNING:
The HubBus Signal –ve line must not be tied to any common, 0V, ground or
Earth points.
HubBus Line Termination Unit
HBLTU USER MANUAL
Figure 3: Terminal Plug
HBLTU
5
Sig +
6
Sig -
7
Sig +
8
Sig -
Table 1: HBLTU Terminals
11 OF 12
Sig +
1
Sig -
2
Sig +
3
Sig -
4
125-258-12
Issue: 01