Hi-Link HLK-LD1125H-24G 애플리케이션 매뉴얼 - 페이지 8

{카테고리_이름} Hi-Link HLK-LD1125H-24G에 대한 애플리케이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Link HLK-LD1125H-24G 17 페이지. Human presence detection radar

test_mode=*，The setup module goes into the test module. When test_mode=1, the

module enters the test module. In the test mode, the module will output the signal strength

str value in addition to the mov and dis information. The module defaults to test_mode=0.

save，Save Settings. Otherwise,

power down and restore the default

value.

get_all，Get the current parameter

settings.

Note: The command needs to be sent with carriage return and line feed to take effect.

Configuration instruction demonstration

Take the serial port assistant window as an example to demonstrate the function

and output of each command:

Send rmax=8, the module will

rmax is

8.00"Indicates that the command configuration is successful. If you do not

receive this feedback, please check whether the sending command has a carriage

return and line feed, and resend the command.

Send mth1=100, the module will feedback

Indicates that the command configuration is successful. If you do not receive this feedback,

please check whether the sending command has a carriage return and line feed, and resend

the command.

feedback"received message: rmax=8

"received message:mth1=80

mth1 is

80"