GReddy Intercooler Kit 설치 매뉴얼 - 페이지 7
{카테고리_이름} GReddy Intercooler Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GReddy Intercooler Kit 7 페이지. For toyota mr-2 turbo (sw-20)
GReddy Intercooler Kit에 대해서도 마찬가지입니다: 사용 설명서 (9 페이지), 설치 매뉴얼 (9 페이지), 설치 매뉴얼 (9 페이지), 설치 매뉴얼 (13 페이지)
페이지 인쇄
2.Install the intake pipes I-3, I-4 from the Intercooler
to the throttle body.
※Use the 50φ-54φhose and hose clamp from the
turbo kit.
3. Starting the Engine
3. Starting the Engine
3. Starting the Engine
3. Starting the Engine
1. Check all the pipe and hose connections, then reconnect the negative side of the battery.
2. Start the engine. While idling, check fom any air leaks.
3.After inspection, reinstall the front bunper, under cover and other stock parts that was
removed.
4.On the initial run, be sure to have a boost gauge to check the turbo-actuator setting. This
turbo kit is preset to boost between 0.3kg/cm
It is very important that you monitor the boost pressure, and make sure not to over boost.
Over boosting can cause engine damage.
(Parts Used #4, 5, 6, 7, 8, 9)
This completes the Intercooler Kit installation.
2
2
to 0.4kg/cm
(4.5-5.5 PSI).