GReddy Intercooler Kit Kurulum Kılavuzu - Sayfa 7
Otomobil Aksesuarları GReddy Intercooler Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. GReddy Intercooler Kit 7 sayfaları. For toyota mr-2 turbo (sw-20)
Ayrıca GReddy Intercooler Kit için: Kullanım Kılavuzu (9 sayfalar), Kurulum Kılavuzu (9 sayfalar), Kurulum Kılavuzu (9 sayfalar), Kurulum Kılavuzu (13 sayfalar)
Sayfayı Yazdır
2.Install the intake pipes I-3, I-4 from the Intercooler
to the throttle body.
※Use the 50φ-54φhose and hose clamp from the
turbo kit.
3. Starting the Engine
3. Starting the Engine
3. Starting the Engine
3. Starting the Engine
1. Check all the pipe and hose connections, then reconnect the negative side of the battery.
2. Start the engine. While idling, check fom any air leaks.
3.After inspection, reinstall the front bunper, under cover and other stock parts that was
removed.
4.On the initial run, be sure to have a boost gauge to check the turbo-actuator setting. This
turbo kit is preset to boost between 0.3kg/cm
It is very important that you monitor the boost pressure, and make sure not to over boost.
Over boosting can cause engine damage.
(Parts Used #4, 5, 6, 7, 8, 9)
This completes the Intercooler Kit installation.
2
2
to 0.4kg/cm
(4.5-5.5 PSI).