activTek AP3000 매뉴얼 - 페이지 13

{카테고리_이름} activTek AP3000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. activTek AP3000 16 페이지. Portable whole home office system
activTek AP3000에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (12 페이지)

페이지 인쇄

TROUBLESHOOTING

Indicators of Operation:

When the unit is on, the LCD display will show either the fan setting and NORMAL, or the fan setting, purifier setting,

and square footage . If the unit is in Away Mode, it will display AWAY MODE plus the hours and minutes remaining . See

page 6 for more information .

Troubleshooting – What to look for first:

1. I have plugged in the unit, pressed the ON button on the remote (or the unit), and nothing happens... what's wrong?

• Make sure the power cord is inserted completely into the receptacle on the back of the unit

• Make sure the electrical outlet is capable of providing power to the unit

• Check to see if the proper fuse is installed and that it is operational

2. The fan is operating but the purifier plate is not working... what's wrong?

• The unit is in Normal Mode (press the Normal/High switch to change to High Mode) .

• If the unit is displaying a REPLACE PLATE message, check the purifier plate for serviceability . If it is cracked or

broken, the purifier plate will require replacement . Ensure maintenance procedures required for the purifier plate

have been performed according to the "Maintenance" section of this owner's manual . Order new purifier plates

from your activTek Distributor .

• The electrical stainless steel contacts are not contacting the screen portion of the purifier plate . Unplug and inspect

the unit for any loose connections .

• Do not attempt to disassemble the unit . This will void the warranty of the product .

3. The purifier plate is making a noise, has a burning smell, and/or appears to arc or spark. What is the problem?

• The purifier plate is most likely cracked . The unit will display a REPLACE PLATE message . Refer to the answers for

question #2, as it would apply to this question also .

4. The UV lamp is not functioning/I'm getting a "Replace RCI Cell" message.

• Check ActivePure® (RCI) Cell for proper installation by removing the back cover and Filter Assembly . Be sure the cell

is properly connected .

• Replace the ActivePure® (RCI) Cell .

5. What are the most typical application problems?

• Symptom: A belief that the proper equipment is placed in the environment and the equipment appears unsuccessful .

Problem: Lack of air movement, improper placement of the unit .

• Symptom: Strong odors still remain within the environment after placement .

Problem: Improper placement of the unit, or the source of the odor has not been eliminated .

• Symptom: A strong odor of ozone is present within the environment .

Problem: Too much ozone accumulation as a result of improper purifier control setting, and/or lack of air movement .

• Symptom: Visual haze of smoke and/or particulate remain within the environment .

Problem: Lack of ionization and/or air movement .

6. Air flow is restricted or reduced.

• Make sure the unit is properly placed away from objects that may obstruct air flow .

• Make sure the Filter Assembly, back cover, and front grill are clean .

• Make sure the ActivePure® (RCI) Cell is clean .