Gallagher T10 설치 참고 사항 - 페이지 5
{카테고리_이름} Gallagher T10에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallagher T10 11 페이지. Reader
Gallagher T10에 대해서도 마찬가지입니다: 설치 참고 사항 (12 페이지), 설치 참고 사항 (12 페이지)
페이지 인쇄
6.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security
screwdriver) through the hole at the bottom of the base to secure the
facia assembly.
Note: The recommended torque for the security screw is 0.7Nm
(0.5 lb/ft). It is important not to exceed the maximum torque of
1.5Nm (1.1 lb/ft).
7.
Removal of the facia assembly is a simple reversal of these steps.
Connections
A Gallagher T10 Mifare reader can connect to one of the following devices
using the "Cardax IV Reader" communications protocol:
•
Cardax FT Reader Module (for the Controller 6000)
•
Cardax FT GBUS Universal Reader Interface (Cardax FT GBUS URI)
•
Cardax FT Controller 3000-4R or 3000-8R
•
Cardax FT Universal Reader Interface (Cardax FT URI)
•
Cardax FT Reader I/O Interface
Facia
Fit screw to secure facia to base
Installation Note | Gallagher T10 Mifare Reader
Reader
Building
tail
cable
Connection
Part Number: 3E2453 R1 | 5