HighPoint RocketRAID 2680 설치 매뉴얼 - 페이지 5
{카테고리_이름} HighPoint RocketRAID 2680에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RocketRAID 2680 8 페이지. Sas controller
페이지 인쇄
Rocket RAID 2680 FreeBSD Installation Guide
If using USB disk, insert it into the USB port. Assume the USB disk's name is disk1
and driver modules are located at the first partition of disk1 in system, then type in
"
load disk1s1:rr2680-x.x
as one partition, i.e. format the USB disk directly without partitioned, type in "
disk1:rr2680-x.x
To confirm USB disk name, type lsdev command.
In the following document we assume the driver diskette is inserted into the
on-board's floppy controller.
for FreeBSD 6.0-RELEASE
ok load disk0:rr2680-6.0.ko
for FreeBSD 6.0-AMD64-RELEASE
ok load disk0:rr2680-6.0-amd64.ko
for FreeBSD 6.1-RELEASE
ok load disk0:rr2680-6.1.ko
for FreeBSD 6.1-AMD64-RELEASE
ok load disk0:rr2680-6.1-amd64.ko
for FreeBSD 6.2-RELEASE
ok load disk0:rr2680-6.2.ko
for FreeBSD 6.2-AMD64-RELEASE
ok load disk0:rr2680-6.2-amd64.ko
for FreeBSD 6.3-RELEASE
ok load disk0:rr2680-6.3.ko
for FreeBSD 6.3-AMD64-RELEASE
ok load disk0:rr2680-6.3-amd64.ko
for FreeBSD 7.0-RELEASE
ok load disk0:rr2680-7.0.ko
for FreeBSD 7.0-AMD64-RELEASE
ok load disk0:rr2680-7.0-amd64.ko
4)
After the driver has been loaded, remove the floppy diskette from the (USB) floppy
drive or remove USB disk from USB port.
5)
Type in "boot" and continue the installation as normal. You can refer to FreeBSD
installation guide.
" (without quotation mark). If whole USB disk is formatted
" (without quotation mark) and then press enter.
load
- 3 -