ADF ADH100ID 보충 지침 - 페이지 6

{카테고리_이름} ADF ADH100ID에 대한 보충 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ADF ADH100ID 17 페이지. Double sided inbuilt heater zero clearance box

ADF 1000 NMV LINEA ZERO CLEARANCE BOX ASSEMBLY INSTRUCTIONS

Minimum Dimensions for Heat Resistant board:

300mm

above ZCB

• Non Combustible Board – Fibre Cement Sheet of 12 or 18mm thick to

prevent cracking, or Skamol Board 40mm or 50mm thick.

• Fix with separate sheets top and bottom, and separate off cuts on each

side. Use the factory cut neat edge to face the heater opening, if not

covering with optional frame or tiling. This is so plastic (will melt) or metal

(will expand and contract) beading is not to be used on the heater opening.

Must leave a 5mm gap between each edge of the heater and the combustible

board to allow for metal expansion.

1445mm to 45mm stud centres.

1355mm opening

1/11/19

1420mm

Fig. 4