Gamma X-Stringer XLT 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gamma X-Stringer XLT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-Stringer XLT 20 페이지. Electronic stringing machine

ASSEMBLY INSTRUCTIONS

Rubber Foot Pad Installation

Insert the two rubber foot pads with the spacer sleeve into the into the threaded holes of the

rails located on the underside of the baser on the right side as shown.

NOTE: If desirted, the Rubber Foot Pads may also be installed on the left side of the

machine base.

Installing the Tool Tray

Hold the tool tray on an angle and align the tabs

on the tool tray with the slots in the machine

base. Rotate the tool tray down and apply

pressure until the tool tray "snaps" into place.

Secure the tool tray with three bolts in the

bottom of the machine base from underneath.

Reverse the steps above to remove the tool

tray for ease of travel.

NOTE: If the Leg Bracket is installed on

the right side of the base, the Tool Tray

must be installed prior to installing the

Leg Bracket.