CORNING EDGE 매뉴얼 - 페이지 9

{카테고리_이름} CORNING EDGE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING EDGE 11 페이지. Single-module housing
CORNING EDGE에 대해서도 마찬가지입니다: 설치 (4 페이지)

Step 4:

If the inner plate was removed from the box to a work surface, return the plate to the box

and secure it with the latches seen in Figure 2 before installing the feeder trunk cables.

Step 5:

Before installing trunk cables, lift cable access panels as shown in Figure 15.

Step 6:

Install the trunk cables in the cradles per bullets 1 and 2 of Figure 16. Feed the cable into

the box through the cable entry locations and slide the cradle feet in the slotted openings in

the plate as shown in bullet 3 of the figure.

Figure 17

Step 7:

STANDARD RECOMMENDED PROCEDURE 003-825-AEN ISSUE 7 | NOVEMBER 2020 | PAGE 9 OF 11

If additional trunk cables are needed,

install a furcation mounting bracket to the

exterior of the box (Figure 17) and mount

the additional trunk cables to the bracket.

Route legs into the box

Figure 15

Figure 16