Jandy AquaLink RS 설치 매뉴얼 - 페이지 3

{카테고리_이름} Jandy AquaLink RS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy AquaLink RS 4 페이지. Battery wireless, portable control panel
Jandy AquaLink RS에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 지침 (1 페이지), 설치 지침 (1 페이지)

페이지 인쇄

Jandy

Controls

3.9.3.

Changing the Transmission Code:

If your AquaLink RS system is turning items on or off at odd times it may be the

result of another AquaLink RS Wireless Controller in close proximity using the same

or similar code. To prevent unwanted operation, the code for your AquaLink RS

Wireless system can be per son al ized. Except for dip switch #8, both the Power

Center Trans ceiv er and the Control Panel Transceiver must be set to the same code.

The Indoor Control Panel Transceiver dip switch #8 must be OFF and the Power

Center Trans ceiv er dip switch #8 must be ON.

1. Go to the Indoor Control Panel and remove the screws to expose the trans ceiv er

2. Locate the small set of dip switches on the Control Panel PCB. Except for dip

3. At the Outdoor Transceiver J-box, remove the cover to expose the Transceiver

Indoor Control Panel

Always OFF

Indoor

Control Panel

Transceiver

PCB

Installation

PCB.

switch #8, turn on one or more dip switches. Important- before installing the

Control Panel cover, press the reset button (SW1). Note which switches

you have turned on then reinstall the cover and screws.

PCB and set the dip switches (except #8) to the same settings as the Control

Panel Transceiver PCB that is in the house. Im por tant- before installing

the J-box cover, press the reset button (SW1). Close the cover and test the

system.

If any DIP Switch is moved,

you must press SW1 to es-

tablish com mu ni ca tion (may

need to press more than one

time).

SW1

Power Center J-Box

Always ON

Power Center