Lexmark C925 빠른 참조 - 페이지 2

{카테고리_이름} Lexmark C925에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark C925 10 페이지. Setup sheet
Lexmark C925에 대해서도 마찬가지입니다: 관리자 매뉴얼 (20 페이지), 관리자 매뉴얼 (12 페이지), 연결 매뉴얼 (7 페이지), 릴리스 노트 (4 페이지), 관리자 매뉴얼 (13 페이지), 유지 관리 매뉴얼 (15 페이지), 매뉴얼 (14 페이지), 관리자 매뉴얼 (12 페이지), 종이 매뉴얼 (3 페이지), 메뉴 맵 (2 페이지), 이동 매뉴얼 (2 페이지), 소모품 매뉴얼 (2 페이지), 정보 매뉴얼 (1 페이지), 인쇄 결함 매뉴얼 (1 페이지), 설치 (2 페이지), 빠른 참조 (12 페이지), 서비스 교육 (18 페이지)

Lexmark C925 빠른 참조
3
Squeeze the length guide tabs together, and then slide the length
guide to the correct position for the paper size being loaded.
4
Flex the sheets back and forth to loosen them. Do not fold or
crease the paper. Straighten the edges on a level surface.
5
Load the paper stack with the recommended print side faceup.
Load the paper in either the long-edge or short-edge orientation
as described at the beginning of this section.
Notes:
Load sizes larger than A4 in the short-edge orientation.
Make sure the paper is below the maximum fill line located
on the edge of the paper tray. Overloading the tray can cause
paper jams and possible printer damage.
Long-edge orientation
Short-edge orientation
6
Adjust both the width and length guides to lightly touch the edge
of the paper stack. Make sure the paper fits loosely in the tray, lies
flat, and is not bent or wrinkled.
7
Lock the width guide.
2
8
Insert the tray.
9
From the printer control panel, set the Paper Size and Paper Type
for the tray based on the paper you loaded.

Loading the multipurpose feeder

The multipurpose feeder can hold several sizes and types of print
media, such as transparencies, labels, card stock, and envelopes. It
can be used for single-page or manual printing, or as an additional
tray.
The multipurpose feeder can hold approximately:
2
50 sheets of 75-g/m
(20-lb) paper
10 envelopes
20 transparencies
Note: Do not add or remove paper or specialty media when the
printer is printing from the multipurpose feeder or when the printer
control panel indicator light is blinking. Doing so may cause a jam.
1
Pull down the multipurpose feeder door.