Fujitsu ScanSnap iX500 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Fujitsu ScanSnap iX500에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iX500 17 페이지. Windows
Fujitsu ScanSnap iX500에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (16 페이지), 빠른 설정 매뉴얼 (3 페이지), 시작하기 (18 페이지), 안전 주의사항 (11 페이지), 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), Wi-Fi 연결 매뉴얼 (41 페이지)

Open the ADF paper chute (cover) of the ScanSnap.

The ScanSnap is powered on and the [Scan] button lights

in blue.

ATTENTION

The bottom of the ScanSnap may become hot when the

ScanSnap is used, but this heat does not affect operation

or cause any physical harm. However, be careful not to

drop the ScanSnap when carrying it.

When the ScanSnap is turned on and left unused for 4

hours, it will turn itself off automatically. To turn the

ScanSnap back on, perform one of the following

operations:

- Press the [Scan] button (Scanning does not start).

- Close the ADF paper chute (cover) and open it again

The time until power-off can be changed. For details, refer to

the Operator's Guide.

HINT

When you close the ADF paper chute (cover), the

ScanSnap will turn off.

Check the ScanSnap Manager icon.

The ScanSnap Manager icon

appears when you click

right of the taskbar.

To have the ScanSnap Manager icon

notification area, drag the icon and drop it onto the notification

area.

ATTENTION

If the ScanSnap Manager icon is

menu. You can reference the appropriate actions for connecting the scanner.

The ScanSnap Manager icon

ATTENTION

If the ScanSnap Manager icon is

[To establish connection] from the menu. You can reference the appropriate actions for connecting

the scanner.

is displayed in the menu that

on the notification area, at the far

always displayed on the

, right-click on

appears in the Dock.

, while holding down the [control] key, click

ADF Paper Chute (cover)

[Scan] Button

and select [To establish connection] from the

and then select