Fujitsu ScanSnap iX500 시작하기 매뉴얼 - 페이지 9
{카테고리_이름} Fujitsu ScanSnap iX500에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iX500 17 페이지. Windows
Fujitsu ScanSnap iX500에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (16 페이지), 빠른 설정 매뉴얼 (3 페이지), 시작하기 (18 페이지), 안전 주의사항 (11 페이지), 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), Wi-Fi 연결 매뉴얼 (41 페이지)
페이지 인쇄
Connecting the ScanSnap
ATTENTION
Only one ScanSnap can be used by a computer at a time.
Use only the cable supplied with the ScanSnap.
Do not use AC adapters other than the one supplied with this ScanSnap. Doing so may
CAUTION
cause damage to the ScanSnap.
1.
Connect the AC cable to the AC adapter
(collectively called the "power cable").
2.
Plug the power cable into the power
connector at the back of the ScanSnap, and
the other end to an AC outlet.
3.
Remove the tape seal on the USB connector
of the ScanSnap.
4.
Connect the USB cable to the USB connector
on the ScanSnap and the USB port on your
computer.
ATTENTION
When connecting to USB hub, make sure to
connect the ScanSnap to the USB hub which is
connected to a USB port of your computer. Use a
powered USB hub (with AC adapter).
If USB port or USB hub is USB 1.1, scanning speed
will slow down.
Connect the USB cable with the USB mark facing
up.
AC Cable
Power Connector
9
AC Adapter
AC Outlet
Power Cable
Tape Seal
USB Cable