Fujitsu Eternus DX200F 운영 매뉴얼 - 페이지 33

{카테고리_이름} Fujitsu Eternus DX200F에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX200F 48 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX200F에 대해서도 마찬가지입니다: 설정 매뉴얼 (10 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (16 페이지), 구성 매뉴얼 (38 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Powering off

Chapter 4

Maintaining Optional Products

4.2

Adding Servers

(3)

Swing the lock lever in the direction of the arrow, until the lock clicks shut.

(4)

Check that the newly installed drive's DRIVE READY LED lights up green.

To install more additional drives, repeat

If a wrist strap is used, remove the wrist strap.

In the [Drives] screen of [Component] on the ETERNUS Web GUI screen, check that the added drives

have been recognized.

Set up RAID groups, volumes, hot spares, and host affinity settings, as required.

4.2

Adding Servers

To connect a new server to ETERNUS DX, preparation is required.

4.2.1

RAID Group Creation

Create RAID groups in order to create volumes to be used by the added server.

If free space in an existing RAID group is used, this procedure can be omitted.

The procedure to register a RAID group is as follows:

Click the [RAID Group] tab on the navigation of the ETERNUS Web GUI screen.

The [RAID Groups] screen appears.

•

Hold the drive with both hands to protect against jarring.

FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)

Lock lever

Step 3

and

Step

P3AM-8472-01ENZ0