Kohler K-1109 설치 매뉴얼 - 페이지 7

{카테고리_이름} Kohler K-1109에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1109 32 페이지. Bath whirlpool
Kohler K-1109에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (36 페이지), 설치 매뉴얼 (36 페이지)

페이지 인쇄
Kohler K-1109 설치 매뉴얼
Drainage

4. Cut the Pump Banding Straps

IMPORTANT! This step is necessary to make your Kohler whirlpool operate more quietly.
- Use tin snips to cut the two pump banding straps from the whirlpool pump.
- To minimize whirlpool noise and vibration, be sure the pump is not in direct contact with the whirlpool harness
after the pump banding straps are cut.

5. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
- Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
- Install the faucet valving according to the faucet manufacturer's instructions. Do not install the faucet trim until
instructed. Open the hot and cold water supplies, and check the supply connections for leakage.
- Run water into the whirlpool, and check the drain connections for leakage.
Kohler Co.
Pump
Suction Line
7
Leave the pump support board
attached to the whirlpool.
Cut the pump
banding straps
Pump Support Bracket
C
1010997-2-