Dell DL4300 배포 매뉴얼 - 페이지 7

{카테고리_이름} Dell DL4300에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell DL4300 33 페이지.
Dell DL4300에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 시스템 시작하기 (2 페이지), 시스템 시작하기 (2 페이지)

페이지 인쇄
Dell DL4300 배포 매뉴얼
To set up the DL Appliance hardware:
1.
Rack and cable the DL4300 system and storage enclosure(s).
2.
Turn on the storage enclosure(s) and then the DL4300 system.

Installing the appliance in a rack

If your system includes a rail kit, locate the Rack Installation Instructions supplied with the rack kit. Follow
the instructions to install the rails in the rack unit, the system, and the storage enclosure in the rack.

Setting the storage enclosure configuration switch

Set the storage mode for the storage enclosure to unified mode as indicated in the following figure.
NOTE: The configuration switch must be set before turning on the storage enclosure. Changing the
configuration mode after turning on the storage enclosure has no effect on enclosure configuration
until the system is power cycled. For more information, see the Dell Storage MD1400 Enclosures
Hardware Owner's Manual at dell.com/support/home.
Figure 1. Setting the PowerVault MD1400 storage enclosure configuration switch
1.
configuration switch

Connecting the storage enclosure to the system

Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the Dell DL4300 system
to the primary Enclosure Management Module (EMM) SAS port of the storage enclosure.
7