Dell DL4300 Посібник з розгортання - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з розгортання для Сервер Dell DL4300. Dell DL4300 33 сторінки.
Також для Dell DL4300: Початок роботи (2 сторінок), Початок роботи з системою (2 сторінок), Початок роботи з системою (2 сторінок)

To set up the DL Appliance hardware:

Rack and cable the DL4300 system and storage enclosure(s).

Turn on the storage enclosure(s) and then the DL4300 system.

Installing the appliance in a rack

If your system includes a rail kit, locate the Rack Installation Instructions supplied with the rack kit. Follow

the instructions to install the rails in the rack unit, the system, and the storage enclosure in the rack.

Set the storage mode for the storage enclosure to unified mode as indicated in the following figure.

NOTE: The configuration switch must be set before turning on the storage enclosure. Changing the

configuration mode after turning on the storage enclosure has no effect on enclosure configuration

until the system is power cycled. For more information, see the Dell Storage MD1400 Enclosures

Hardware Owner's Manual at dell.com/support/home.

Figure 1. Setting the PowerVault MD1400 storage enclosure configuration switch

configuration switch

Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the Dell DL4300 system

to the primary Enclosure Management Module (EMM) SAS port of the storage enclosure.