Dell PowerVault MD3660i Series Storage Array 문제 해결 매뉴얼 - 페이지 8

{카테고리_이름} Dell PowerVault MD3660i Series Storage Array에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3660i Series Storage Array 18 페이지. Storage arrays
Dell PowerVault MD3660i Series Storage Array에 대해서도 마찬가지입니다: 하드웨어 및 소프트웨어 매뉴얼 (25 페이지), 설치 매뉴얼 (11 페이지), 시작하기 매뉴얼 (10 페이지), 정보 업데이트 (8 페이지), 랙 설치 지침 (2 페이지), 설정 (2 페이지), 문제 해결 매뉴얼 (20 페이지), 배포 매뉴얼 (24 페이지)

Troubleshooting the Ethernet Management Port

The Ethernet management ports on the MD-series RAID controllers allow you to manage your storage

array via a separate management network from the host server data path (known as out-of-band

management).

Dell recommends always using out-of-band management to manage your storage array.

Each RAID controller module contains a 100/1000 Mbps Ethernet management port. Whether you are

using SAS, iSCSI or Fibre Channel, the management port is located in same same position.

Figure 4 shows the management ports on an MD3600i-series iSCSI storage array.

Figure 4. Management Ports on an MD3600i-series storage array

Each port on the storage array is assigned a default, factory-set IP address. Since DHCP is enabled by

default for the management ports at the factory (however, not for the host server ports), these

addresses should be discoverable when the storage array is initially powered on.

Table 1. Default IP Addresses on MD-series storage array (all models)

Port ID

iSCSI port 0

iSCSI port 1

iSCSI port 2

iSCSI port 3

Ethernet

management port

* Port 2 and 3 are available on 1Gb iSCSI MD3200i-series storage arrays only

Controller 0

192.168.130.101

192.168.131.101

192.168.132.101

192.168.133.101

192.168.128.101

Controller 1

192.168.130.102

192.168.131.102

192.168.132.102

192.168.133.102

192.168.128.102

Subnet mask

255.255.255.0