Epson 1730W - PowerLite WXGA LCD Projector 설치 핸드북 - 페이지 11

{카테고리_이름} Epson 1730W - PowerLite WXGA LCD Projector에 대한 설치 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 1730W - PowerLite WXGA LCD Projector 11 페이지. Esc/vp21 command business projectors
Epson 1730W - PowerLite WXGA LCD Projector에 대해서도 마찬가지입니다: 부품 목록 (1 페이지), 빠른 설정 매뉴얼 (2 페이지), 적합성 선언 (4 페이지), 사양 (2 페이지), 사용자 설명서 (1 페이지), 사용자 설명서 (25 페이지), 빠른 설정 (2 페이지)

페이지 인쇄

Epson 1730W - PowerLite WXGA LCD Projector 설치 핸드북

Epson PowerLite 1720 / 1730W

note

If you're using a remote

control ID other than the

default ID of zero, you have

to set the ID each time you

turn on the projector.

2. Press the

button on the remote control. You see a message on

the screen, showing the projector's ID:

If the message says the remote control is "On," then you can use

the remote control to operate that projector. If it says "Off," then

you have to change the ID of the remote control before operation

is possible, as described in the next section.

Setting the Remote Control ID

The remote control's default ID is zero. This lets it operate any

projector. To set it to operate only those projectors with a specific ID,

follow these steps:

1. Press and hold the

2. While holding the

remote control (1 through 9) that corresponds to the ID of the

projector(s) you want to operate. Selecting zero lets you control all

projectors.

INSTALLATION HANDBOOK

button on the remote control.

button, press the numbered button on the

Remote Control Information