Cisco IP DECT 6825 하드웨어 설치 - 페이지 11

{카테고리_이름} Cisco IP DECT 6825에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IP DECT 6825 18 페이지. Masergy
Cisco IP DECT 6825에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (37 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

Hardware Installation

• Ensure that the base station can communicate with the network (see

5). After it can communicate and the LED is green, you can unplug the cables.

Determine the best placement, taking into account the coverage area and the building construction materials.

You may need to install addition base stations for best coverage.

You can use the site survey tool on the handset to plan placement.

Procedure

Step 1

Hold the level in the desired location and at least 2.25 inches (5.7 cm) below the ceiling, and draw a level

line.

Step 2

Mark the placement of the screws.

• Without the ceiling mount bracket: Mark the line so that the screws are 2.126 inches (54 mm) apart

(center to center).

• With the ceiling mount bracket: Hold the bracket so that two of the holes intersect the line. Mark the

holes.

Step 3

Install the wall plugs as described by the manufacturer.

Step 4

Insert the screws.

• Without the ceiling mount bracket: Screw in the screws until there is about 0.375 inches (9.52 mm)

between the screw head and the wall.

Mount the Base Station on the Wall

Install the Base Station, on page

Hardware Installation