Cisco NCS 4000 Series 문제 해결 매뉴얼 - 페이지 20

{카테고리_이름} Cisco NCS 4000 Series에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 4000 Series 44 페이지. Network convergence system
Cisco NCS 4000 Series에 대해서도 마찬가지입니다: 포장 풀기, 이동 및 고정 매뉴얼 (40 페이지)

페이지 인쇄

Clear the EJECTOR-FLAPS-OPEN Alarm

Procedure

For RP, remove the card and replace. For fabric cards and line cards, close the ejector flaps.

If the condition does not clear, log into the Technical Support Website

support/index.html

FC-REDUNDANCY-LOST

Default Severity: Major (MJ) or Critical (CR), Non-Service-Affecting (NSA), or Service-Affecting (SA)

Logical Object: PORT

The Fabric Card Redundancy alarm occurs when one or more than one fabric card is removed.

Clear the FC-REDUNDANCY-LOST Alarm

Procedure

Either plug in 3 or all 4 fabric cards.

If the condition does not clear, log into the Technical Support Website

support/index.html

FEC-MISM

Default Severity: Major (MJ), Service-Affecting (SA)

Logical Object: PORT

FEC Mismatch alarm occurs when there is a FEC configuration mismatch in a span.

Clear the FEC MISM Alarm

Procedure

Step 1

Check the configured FEC type on the controller and the connected port.

Step 2

This alarm is triggered, when the FEC type of the controller and the connected port are different. Set the same

FEC type for the controller and the connected port.

The available FEC types are:

• Disable

Alarms Troubleshooting Guide for Cisco NCS 4000 Series

for more information or call Cisco TAC (1 800 553-2447).

Alarm Management

athttp://www.cisco.com/cisco/web/