Cisco NCS 5500 Series 연결 매뉴얼 - 페이지 11

{카테고리_이름} Cisco NCS 5500 Series에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 5500 Series 24 페이지. Connect router to the network
Cisco NCS 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 매뉴얼 (25 페이지)

페이지 인쇄
Cisco NCS 5500 Series 연결 매뉴얼
Connect Router to the Network
Note
Avoid over torquing the MPA captive screws when installing the MPA. Tighten the captive screws on the
MPA to a torque of 6 +/-0.5 inch-pound.
4. To remove the MPA from the chassis, use a number 2 Phillips screwdriver to loosen the captive screws
on the MPA. Ensure that you first loosen the right screw and then the left.
5. Grasp the MPA and pull the MPA from the chassis. (You have already disconnected the cables from the
MPA.)

Installing Dust Caps

Install dust caps to protect unused or unconnected optical ports on the NCS-55A2-MOD chassis and MPAs.
The following list provides the product IDs (PIDs) for the dust caps that are available for each port type:
PID
NC55-SFP-DCAP(=)
NC55-QSFP-DCAP(=)
NC55-CFP2-DCAP(=)
Note
Dust caps are orderable separately from Cisco and are available for a variety of input/output connectors.
Figure 8: Dust Cap
To install the dust cap:
1. Hold the dust cap by its handle.
Description
Cisco NCS5500 Series Dust cover for SFP/ZSFP (Qty: 1 per Kit)
Cisco NCS5500 Series Dust cover for QSFP/ZQSFP (Qty: 1 per Kit)
Cisco NCS5500 Series Dust cover for CFP2 (Qty: 1 per Kit)
Connect Router to the Network
Installing Dust Caps
11