Cisco NCS 5500 Series 연결 매뉴얼 - 페이지 12

{카테고리_이름} Cisco NCS 5500 Series에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 5500 Series 24 페이지. Connect router to the network
Cisco NCS 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 매뉴얼 (25 페이지)

페이지 인쇄

Install and Remove Transceiver Modules

2. Insert the dust cap in to the appropriate unused ports (SFP, QSFP, CFP2) on the chassis or MPA front

panel.

Install and Remove Transceiver Modules

Install and Remove SFP Modules

Before you remove or install an SFP or SFP+ module, read the installation information in this section.

Warning

Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or

view directly with optical instruments. Statement 1051

Caution

Protect the line card by inserting a clean SFP/SFP+ module cage cover, shown in the figure below, into the

optical module cage when there is no SFP or SFP+ module installed.

Figure 9: SFP/SFP+ Module Cage Cover

Caution

Protect the SFP or SFP+ modules by inserting clean dust covers into them after the cables are removed. Be

sure to clean the optic surfaces of the fiber cables before you plug them back into the optical ports of another

module. Avoid getting dust and other contaminants into the optical ports of your SFP or SFP+ modules,

because the optics do not work correctly when obstructed by dust.

Connect Router to the Network