Cisco SG 300-10P 빠른 시작 매뉴얼 - 페이지 10
{카테고리_이름} Cisco SG 300-10P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SG 300-10P 17 페이지. Managed switches
Cisco SG 300-10P에 대해서도 마찬가지입니다: 데이터시트 (14 페이지), 사양 (2 페이지), 빠른 설정 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
- 1. Quick Start Guide
- 2. Mounting the Cisco Switch
- 3. Wall Mounting
- 4. Rack-Mount Placement
- 5. Connecting Network Devices
- 6. Power over Ethernet (Poe) Considerations
- 7. Managing Switch Using Web-Based Interface
- 8. Troubleshoot Your Connection
- 9. Front Panel Ports
- 10. Front Panel Leds
- 11. Additional Front Panel Features
- 12. Back Panel
- 13. Where to Go from here
Front Panel LEDs
System LED—(Green) Lights steady when the switch is powered on, and
flashes when booting, performing self tests, and acquiring an IP address. If
the LED flashes Amber, the switch has detected a hardware failure.
LINK/ACT LED—(Green) Located on the left of the port. Lights steady
when a link between the corresponding port and another device is
detected. Flashes when the port is passing traffic.
The System and LINK/ACT LEDs are on each model of the switch.
N
OTE
The following LEDs are only present on switch models that have those
capabilities:
PoE (if present)—(Amber) Located on the right of the port. Lights steady to
indicate that power is being supplied to a device attached to the
corresponding port.
100M LED (if present)—(Green) Located on the right of the port. Lights
steady when another device is connected to the port, is powered on, and a
100 Mbps link is established between the devices. When the LED is off, the
connection speed is under 100 Mbps or nothing is cabled to the port.
Gigabit LED (if present)—(Green) Located on the right of the port. Lights
steady when another device is connected to the port, is powered on, and a
1000 Mbps link is established between the devices. When the LED is off,
the connection speed is under 1000 Mbps or nothing is cabled to the port.
MiniGBIC (if present)—(Green) Located on the right of the port. Lights
steady when a connection is made through the shared RJ-45 port. Flashes
when the port is passing traffic.
Additional Front Panel Features
The switch also has a reset button.
The switch can be reset by inserting a pin or paper clip into the reset
opening. See
"Returning the Device to the Factory Default Settings"
details.
10
300 Series Managed Switches
for