Cisco SG 300-10P 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Cisco SG 300-10P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SG 300-10P 17 페이지. Managed switches
Cisco SG 300-10P에 대해서도 마찬가지입니다: 데이터시트 (14 페이지), 사양 (2 페이지), 빠른 설정 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
- 1. Quick Start Guide
- 2. Mounting the Cisco Switch
- 3. Wall Mounting
- 4. Rack-Mount Placement
- 5. Connecting Network Devices
- 6. Power over Ethernet (Poe) Considerations
- 7. Managing Switch Using Web-Based Interface
- 8. Troubleshoot Your Connection
- 9. Front Panel Ports
- 10. Front Panel Leds
- 11. Additional Front Panel Features
- 12. Back Panel
- 13. Where to Go from here
Mechanical Overloading—The device should be level, stable, and
secure to prevent it from sliding or shifting out of position.
Circuit Overloading—Adding the device to the power outlet must not
overload that circuit.
Rack-Mount Placement
To rack-mount the switch in any standard rack, attach the rack–mount
brackets to the sides of the switch with the supplied hardware and secure
the brackets tightly.
For stability, load the rack from the bottom to the top, with the
C
AUTION
heaviest devices on the bottom. A top-heavy rack is likely to
be unstable and may tip over.
Wall Mounting
Only the 8-port models of the switch can be wall-mounted.
The switch should be mounted so that the ports face up or down.
N
OTE
Do not mount the switch with the ports to the side.
There is a wall-mount kit packed with your switch. The dimensions for the
mount kit are as follows:
2
1 8 mm/0.4 in
Mount the managed switch to the wall by drilling two pilot holes
3.7 inches (95 mm) apart, attaching the provided anchors and screws to
the wall, then sliding the switch into position on the screws.
The switch should have a minimum of 5 inches (130 mm) of clearance on all
sides.
300 Series Managed Switches
1
3
2 22.2 mm/0.9 in 3 6.8 mm/0.3 in 4 17.6 mm/0.7 in
4
3