Cisco 2100 Series 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 2100 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2100 Series 49 페이지. Cisco 8500 series wireless lan controller
Cisco 2100 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 구성 매뉴얼 (50 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

• Status of the 802.11a, 802.11b, and 802.11g networks, either enabled or disabled.

• Status of radio resource management (RRM), either enabled or disabled.

Choosing a Physical Location

You can install the controller almost anywhere, but it is more secure and reliable if you install it in a

secure equipment room or wiring closet. For maximum reliability, mount the controller while

following these guidelines:

• Make sure you can reach the controller and all cables attached to it.

• Make sure that water or excessive moisture cannot get into the controller.

• Make sure that airflow through the controller is not obstructed. Leave at least 4 in. (10 cm) clear

on both sides of the controller.

• Verify that the ambient temperature remains between 32 to 104° F (0 to 40° C).

• Make sure that the controller is within 328 ft. (100 m) of equipment connected to the

10/100BASE-T ports.

• Make sure that the power cord can reach a 100 to 240 VAC grounded electrical outlet.

Connecting the Controller's Console Port

Do not connect a Power over Ethernet (PoE) cable to the console port. Doing so will

Caution

damage the controller.

Before you can configure the controller for basic operations, you need to connect it to a PC that uses

a VT-100 terminal emulator (such as HyperTerminal, ProComm, Minicom, or Tip). Follow these steps

to connect the PC to the controller's console port:

Plug the RJ-45 connector on a null-modem serial cable into the controller's console port and

Step 1

the other end of the cable into the PC's serial port.

Start the PC's terminal emulation program.

Step 2