Cisco 6160 설치 및 교체 참고 사항 - 페이지 3
{카테고리_이름} Cisco 6160에 대한 설치 및 교체 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6160 18 페이지. Without a pots splitter configuration
Cisco 6160에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (38 페이지), 하드웨어 설치 매뉴얼 (21 페이지), 설치 절차 매뉴얼 (32 페이지)
Faceplate Features
Figure 2
Figure 2
1
1
2
To power down a Cisco 6160 that has two PEMs installed, you must flip the circuit breakers on both
Note
PEMs to the Off (0) position.
Table 1
Table 1
LED
INPUT OK
OUT FAIL
OL-2181-01
shows a close-up of the PEM faceplate.
PEM Faceplate
!
CAUTION
!
ATTENTION
!
PRECAUCION
!
ACHTUNG
!
2
INPOUT OK
OUTPUT FAIL
3
Two-position circuit breaker. The positions
are Off (0) and On (1).
INPUT OK LED.
describes the LEDs on the PEM.
PEM LEDs
State
Function
Green
–48VDC power is available to the chassis.
Off
The PEM has a power failure.
Red
One or both of the following conditions exists:
OUT FAIL LED.
3
The PEM is not distributing power to the chassis.
•
The PEM is not distributing power to its cooling fans.
•
Introduction
Faceplate Features
3