Cisco ASA 5506W-X 구성 매뉴얼 - 페이지 2

{카테고리_이름} Cisco ASA 5506W-X에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 13 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

페이지 인쇄
Cisco ASA 5506W-X 구성 매뉴얼
Prerequisites
This document only applies to the initial configuration of a Cisco ASA5506W-X device that
contains a wireless access point and is only intended to address the various changes needed
when you modify the existing IP addressing scheme or add additional wireless VLANs. For default
configuration installations, the existing
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ASA 5506W-X device
Client machine with a terminal emulation program such as Putty, SecureCRT, etc.
Console Cable and Serial PC Terminal Adapter (DB-9 to RJ-45)
Components Used
The information in this document is based on these software and hardware versions:
Cisco ASA 5506W-X device
Client machine with a terminal emulation program such as Putty, SecureCRT, etc.
Console Cable and Serial PC Terminal Adapter (DB-9 to RJ-45)
ASA FirePOWER Module
Integrated Cisco Aironet 702i wireless access point (Built-in WAP)
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.

Network Diagrams

As shown in this image, examples of the IP addressing that will be applied in two different
topologies:
ASA + FirePOWER with an inside switch:
ASA 5506-X Quick Start Guide
must be referenced.