Cisco Gigabit Switch Router Cisco 12012 교체 지침 매뉴얼 - 페이지 14
{카테고리_이름} Cisco Gigabit Switch Router Cisco 12012에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Gigabit Switch Router Cisco 12012 34 페이지. Gigabit switch router cablemanagement
kit
Cisco Gigabit Switch Router Cisco 12012에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (6 페이지), 데이터시트 (9 페이지), 교체 지침 매뉴얼 (20 페이지), 설치 지침 매뉴얼 (14 페이지)
페이지 인쇄
Removing and Replacing a Card Cage Assembly
Step 7
Step 8
Step 9
Repeat Step 7 through Step 9 for the rest of the line cards.
Figure 6
a
b
c
Removing a RP From the Upper Card Cage
The RP can occupy slot 0 through 11 in the upper card cage. Perform the following steps to remove
a RP from the upper card cage:
Step 1
Step 2
14 Cisco 12012 Gigabit Switch Router Card Cage Assembly Replacement Instructions
Proceeding from left to right in the upper card cage, select a line card and loosen the two
captive screws located at the top and bottom of the line card (Refer to Figure 6a.)
Pivot the two card ejector levers out, away from the card to unseat the card from the
backplane connector. (Refer to Figure 6b.)
Grasp the card carrier edge with one hand and place your other hand under the carrier to
support it. (Refer to Figure 6c.) Slide the card out of the slot and place it immediately on
the antistatic mat.
Removing a Line Card From the Upper Card Cage
Loosen
captive
screws
Pivot ejector
levers away
from card to
unseat card
Line card
Grasp card carrier to
slide card out of slot
Attach an antistatic wrist strap to yourself and to one of the two ESD connection sockets
located on the front edges of the upper card cage or to bare metal on the frame.
Disconnect all of the interface cables attached to RP interface connector. Carefully set the
interface cables aside.