Cisco Gigabit Switch Router Cisco 12012 교체 지침 매뉴얼 - 페이지 15
{카테고리_이름} Cisco Gigabit Switch Router Cisco 12012에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Gigabit Switch Router Cisco 12012 34 페이지. Gigabit switch router cablemanagement
kit
Cisco Gigabit Switch Router Cisco 12012에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (6 페이지), 데이터시트 (9 페이지), 교체 지침 매뉴얼 (20 페이지), 설치 지침 매뉴얼 (14 페이지)
페이지 인쇄
Step 3
Step 4
Step 5
Figure 7
a
b
c
Removing an Alarm Card From the Upper Card Cage
The alarm card occupies the rightmost slot (labeled alarm) in the upper card cage.
Perform the following steps to remove an alarm card from the upper card cage:
Step 1
Step 2
Loosen the two captive screws at the top and bottom of the RP. (Refer to Figure 7a.)
Pivot the two ejector levers out, away from the card, to unseat the card from the backplane
connector. (Refer to Figure 7b.)
Grasp the card carrier edge with one hand and place your other hand under the carrier to
support it. (Refer to Figure 7c.) Slide the card out of the slot and place it immediately on
the antistatic mat.
Removing a RP From the Upper Card Cage
Loosen
captive
screws
Pivot ejector
levers away
from card to
unseat card
GRP
Grasp card carrier to
slide card out of slot
Attach an antistatic wrist strap to yourself and to one of the two ESD connection sockets
located on the front edges of the upper card cage or to bare metal on the frame.
Disconnect any interface cables attached to the alarm card connectors.
Cisco 12012 Gigabit Switch Router Card Cage Assembly Replacement Instructions
Removing and Replacing a Card Cage Assembly
15