Cisco UCS B200 M4 서비스 매뉴얼 - 페이지 2
{카테고리_이름} Cisco UCS B200 M4에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M4 24 페이지. For e5-2600 v4 series cpus
Cisco UCS B200 M4에 대해서도 마찬가지입니다: 설치 및 서비스 참고 사항 (30 페이지), 설치 및 서비스 참고 사항 (46 페이지), 업그레이드 매뉴얼 (9 페이지)
페이지 인쇄
Removing a Blade Server Hard Drive
Note
See also
Removing a Blade Server Hard Drive
To remove a hard drive from a blade server, follow these steps:
Procedure
Step 1
Push the button to release the ejector, and then pull the hard drive from its slot.
Step 2
Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another
server.
Step 3
Install a hard disk drive blank faceplate to keep dust out of the blade server if the slot will remain empty.
Installing a Blade Server Drive
To install a drive in a blade server, follow these steps:
Procedure
Step 1
Place the drive ejector into the open position by pushing the release button.
Figure 1: Installing a Hard Drive in a Blade Server
Step 2
Gently slide the drive into the opening in the blade server until it seats into place.
Step 3
Push the drive ejector into the closed position.
You can use Cisco UCS Manager to format and configure RAID services. For details, see the Configuration
Guide for the version of Cisco UCS Manager that you are using. The configuration guides are available at
the following URL:
http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html
Servicing a Blade Server
2
4K Sector Format SAS/SATA Drives Considerations, on page
Servicing a Blade Server
3.