Cisco UCS B200 M4 Servis Kılavuzu - Sayfa 2

Sunucu Cisco UCS B200 M4 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Cisco UCS B200 M4 24 sayfaları. For e5-2600 v4 series cpus
Ayrıca Cisco UCS B200 M4 için: Kurulum ve Servis Notu (30 sayfalar), Kurulum ve Servis Notu (46 sayfalar), Yükseltme Kılavuzu (9 sayfalar)

Sayfayı Yazdır

Removing a Blade Server Hard Drive

Note

See also

Removing a Blade Server Hard Drive

To remove a hard drive from a blade server, follow these steps:

Procedure

Step 1

Push the button to release the ejector, and then pull the hard drive from its slot.

Step 2

Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another

server.

Step 3

Install a hard disk drive blank faceplate to keep dust out of the blade server if the slot will remain empty.

Installing a Blade Server Drive

To install a drive in a blade server, follow these steps:

Procedure

Step 1

Place the drive ejector into the open position by pushing the release button.

Figure 1: Installing a Hard Drive in a Blade Server

Step 2

Gently slide the drive into the opening in the blade server until it seats into place.

Step 3

Push the drive ejector into the closed position.

You can use Cisco UCS Manager to format and configure RAID services. For details, see the Configuration

Guide for the version of Cisco UCS Manager that you are using. The configuration guides are available at

the following URL:

http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html

Servicing a Blade Server

4K Sector Format SAS/SATA Drives Considerations, on page

Servicing a Blade Server